LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air intake pipe. Refer to Air Intake Pipe Replacement .
  2. Disconnect the intake air temperature (IAT) sensor electrical connector (1).
    Fig 1: Disconnecting IAT Sensor Electrical Connector
    GM1602068Courtesy of GENERAL MOTORS CORP.
  3. Remove the IAT sensor from the center intake manifold.
scientia non olet · About LEMON Manuals