LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Glow Plug Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the glow plug control module bracket, if required.
    Fig 1: Installing Glow Plug Control Module Bracket
    GM1612208Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice .
  2. Install the glow plug control module bracket bolts, if required.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Install the glow plug control module.
    Fig 2: Installing Glow Plug Control Module
    GM1602069Courtesy of GENERAL MOTORS CORP.
  4. Install the glow plug control module bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 3: Connecting Glow Plug Control Module Electrical Connectors
    GM1653265Courtesy of GENERAL MOTORS CORP.
  5. Connect the glow plug control module electrical connectors (1, 2).
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
  7. If a NEW glow plug control module was installed, program the module. Refer to Control Module References .
scientia non olet · About LEMON Manuals