LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Sending Unit And Seal
    GM1488784Courtesy of GENERAL MOTORS CORP.
  1. Install the sending unit and a NEW seal.
    2. IMPORTANT: Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. DO NOT apply any type of lubrication in the seal groove.
    Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
    Fig 2: Identifying Lock Ring
    GM1642096Courtesy of GENERAL MOTORS CORP.
  2. Use the J 45722  in order to install the fuel sender lock ring. Turn the fuel sender lock ring in a clockwise direction.
  3. Connect the fuel lines to the sending unit. Refer to Quick Connect Fitting(s) Service (Metal Collar)  or Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
scientia non olet · About LEMON Manuals