Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the fuel pressure sensor (3).
Tighten: Tighten the sensor to 70 N.m (52 lb ft).
- Connect the fuel rail pressure sensor electrical connector (4).
- Install the EGR cooler heat protector (2) and bolt (1).
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
- Install the EGR cooler tube. Refer to Exhaust Gas Recirculation (EGR) Valve Cooler Tube Replacement .
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Prime the fuel system. Refer to Fuel System Priming .
- Start the engine. If the engine stalls, repeat the above step.
- Once the engine starts, inspect for fuel leaks.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.