LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (Cab/Chassis - Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
  2. Disconnect the fuel level sensor electrical connector (1).
    Fig 1: Fuel Level Sensor Electrical Connector, Locking Tangs & Retaining Clip
    GM740113Courtesy of GENERAL MOTORS CORP.
  3. Remove the sensor retaining clip (3).
  4. Squeeze the locking tangs (2) and remove the fuel level sensor.
scientia non olet · About LEMON Manuals