LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Injection Pump Replacement >> Preparing Fuel Injection Pump

Preparing Fuel Injection Pump

WARNING: This page is about a different variant/trim than selected.
  1. Hold the fuel pump by the drive gear in a vice with copper jaw liners.
  2. Loosen the gear nut until the nut is even with the end of the gear shaft.
  3. Remove the gear from the tapered shaft of the injection pump.
  4. Separate the injection pump and adapter by removing the 3 bolts and spacers.
  5. Inspect the O-ring for damage on the pump adapter and replace, if necessary. Lubricate the O-ring with clean engine oil.
  6. Clean all mating surfaces.
  7. Install the adapter on the pump.
    NOTE: Refer to Fastener Notice .
  8. Install the 3 bolts and spacers.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  9. Install the gear and nut.

    Tighten:  Tighten nut to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals