LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis (Cab/Chassis w/Balance Pump) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Bundle (Cab/Chassis w/Balance Pump)
    GM1228195Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the fuel bundle.
  2. Install the fuel bundle nuts.

    Tighten:  Tighten the nuts to 16 N.m (12 lb ft).

    3. Fig 2: Connecting Balance Pump Electrical Connector (Cab/Chassis - Rear)
    GM1333147Courtesy of GENERAL MOTORS CORP.
  3. Connect the pressure balance pump electrical connector.
  4. Install the front and auxiliary fuel tanks. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
scientia non olet · About LEMON Manuals