LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Filler Hose Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the caps from the fuel and vent holes in the fuel tank.
  2. Install the fuel fill and vent hoses to the tank.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill and vent hose clamps (1, 2) at the tank.

    Tighten:  Tighten the clamp to 2.5 N.m (22 lb in).

  4. Connect the fuel feed and pressure balance rear lines. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    Fig 2: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals