LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Feed Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Feed Pipe & Bolts
    GM1335584Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the fuel feed pipe.
  2. Install the fuel feed pipe nut and clip bolts.

    Tighten:  Tighten the bolts/nut to 41 N.m (30 lb ft).

    3. Fig 2: View Of Exhaust Gas Recirculation (EGR) Coolant Pipe, Hose & Bolts
    GM1335419Courtesy of GENERAL MOTORS CORP.
  3. Install the EGR coolant pipe.
  4. Install the EGR coolant pipe bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  5. Install the EGR coolant pipe hose.
  6. Position the EGR coolant pipe hose clamp.
  7. Install the oil level indicator tube bracket and bolts.
    Fig 3: Installing Bracket Bolts
    GM1601448Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the bolts to 21 N.m (15 lb ft).

  8. Install the oil level indicator tube bolt.

    Tighten:  Tighten the bolt to 21 N.m (15 lb ft).

  9. Connect the fuel feed line quick connect fitting. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  10. Install the water outlet tube. Refer to Water Outlet Tube Replacement (6.6L (LLY) Engine) .
  11. Prime the fuel system. Refer to Fuel System Priming .
  12. Start the engine. If the engine stalls, repeat the above step.
  13. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals