LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation (EGR) Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW EGR valve/solenoid assembly gasket (2).
    Fig 1: View Of EGR Valve Assembly
    GM1401821Courtesy of GENERAL MOTORS CORP.
  2. Install the EGR valve/solenoid assembly (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the EGR valve bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  4. Install the EGR cooler tube. Refer to Exhaust Gas Recirculation (EGR) Valve Cooler Tube Replacement .
scientia non olet · About LEMON Manuals