LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
  2. Remove the right wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  3. Disconnect the crankshaft position (CKP) sensor electrical connector.
    Fig 1: View Of Crankshaft Position Sensor Electrical Connector
    GM1335470Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP sensor bolt.
  5. Remove the CKP sensor.
    Fig 2: View Of CKP Sensor & Bolt
    GM1336119Courtesy of GENERAL MOTORS CORP.
  6. If necessary, remove the CKP sensor spacer bolts.
  7. If necessary, remove the CKP sensor spacer.
scientia non olet · About LEMON Manuals