Air Inlet Grille Panel Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Air Inlet Panel & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the fixed antenna, if equipped. Refer to Radio Antenna Replacement . Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (LD) . Remove the rear hood seal. Refer to Hood Rear Seal Replacement . Remove the two outer clips securing the air inlet grille panel to the flange on the air plenum.
1	Air Inlet Grille Panel End Panel (Qty: 2)
2	Air Inlet Grille Panel Retainer (Qty: 2)
3	Air Inlet Grille Panel Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 1.3 N.m (12 lb in)
4	Air Inlet Grille Panel Clip
5	Air Inlet Grille Panel