LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.
    Fig 1: View Of MAF/IAT Sensor Adapter & Clamp
    GM1703691Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor to the air cleaner assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the MAF/IAT sensor adapter clamp.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

    3. Fig 2: View Of Throttle Body Heater Hose & Retainers
    GM1703498Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the MAF/IAT sensor.
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About LEMON Manuals