LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Chassis Wiring Harness Electrical Connector
    GM1855445Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the chassis wiring harness electrical connector (1) from the fuel pressure sensor.
    3. Fig 2: Fuel Pressure Sensor
    GM1855447Courtesy of GENERAL MOTORS CORP.
  3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
  4. Remove the fuel pressure sensor from the fuel line.
  5. Remove and discard the fuel pressure sensor O-ring seal.
scientia non olet · About LEMON Manuals