LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (15 Ext/Crew Cab w/26 gal Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor Electrical Connectors
    GM1854694Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement (15 Reg Cab w/26 gal Tank)  or Fuel Tank Fuel Pump Module Replacement (15 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Fuel Pump Module Replacement (25 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Fuel Pump Module Replacement (15/25 Reg/Ext/Crew Cab w/34 gal Tank)  or Fuel Tank Fuel Pump Module Replacement (35 Reg/Ext/Crew Cab w/34 gal Tank) .
  2. Disconnect the fuel level sensor wiring pigtail electrical connector (1) from the module cover.
    3. Fig 2: Sensor Clip & Retainers
    GM1854696Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel level sensor wiring pigtail from under the module clip (2).
  4. Gently push in the fuel level sensor retainers (1), disengaging them from the module reservoir.
    5. Fig 3: Fuel Level Sensor
    GM1854697Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor up, in order to remove the sensor from the module slot.
scientia non olet · About LEMON Manuals