LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement (15 Ext/Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister & Bracket
    GM1855746Courtesy of GENERAL MOTORS CORP.
  1. If replacing the EVAP canister perform the following steps, otherwise proceed to step 3.
  2. Install the EVAP canister bracket to the canister.
    3. Fig 2: EVAP Canister & Nut
    GM1855669Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP canister assembly.
    4. NOTE: Refer to Fastener Notice .
  4. Install the EVAP canister nut (1).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    5. Fig 3: EVAP Vent Solenoid Pipe Quick Connect Fitting, Retainer & Pipe Clip
    GM1855666Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister vent solenoid pipe quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 4: Quick Connect Fittings
    GM1854683Courtesy of GENERAL MOTORS CORP.
  6. Connect the chassis EVAP pipe quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel tank EVAP pipe quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals