Installation Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the NEW air filter element.
- Install the air cleaner housing cover.
- Tighten the air cleaner housing screws.
Tighten: Tighten the screws to 3 N.m (27 lb in).
- Connect the engine harness electrical connector (2) to the MAF/IAT sensor.
NOTE:
Refer to Fastener Notice
.