Rear Side Door Window Weatherstrip Replacement (Extended Cab)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Door Rear Window Weatherstrip, Rear Door Front Window Weatherstrip & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) . Remove the rear door inner sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement (Crew Cab) or Rear Door Window Belt Inner Sealing Strip Replacement (Extended Cab) .
1	Rear Door Rear Window Weatherstrip Bolt NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Rear Door Rear Window Weatherstrip Procedure: After the bolt has been removed from the weatherstrip, pull downward to release it from the door.
3	Rear Door Front Window Weatherstrip Bolt Tighten: 10 N.m (89 lb in)
4	Rear Door Front Window Weatherstrip Procedure: After the bolt has been removed from the weatherstrip, pull downward to release it from the door.