Rear Side Door Window Regulator Replacement (Crew Cab, Manual)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Window Regulator & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) . Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Rear Side Door Window Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Procedure Tape the window to the door frame to prevent it from moving. Loosen the 2 bolts that attach the window to the window regulator. Tighten: 9 N.m (80 lb in)
2	Rear Side Door Window Regulator Bolt (Qty: 5) Tighten: 9 N.m (80 lb in)
3	Rear Side Door Window Regulator