Rear Door Lock Replacement (Crew Cab)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Lock & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (YE9) or Rear Side Door Trim Panel Replacement (SLT) . Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
1	Inside Door Handle Cable Retainer Clip
2	Rear Side Door Lock Screw (Qty: 3) NOTE: Refer to Fastener Notice . Procedure Release the outside door handle rod from the door lock clip. The mandatory sequence is 3, 1, 2. Tighten: 10 N.m (89 lb in)
3	Rear Side Door Lock Procedure Disconnect the electrical plug. Transfer all parts to the new lock.