Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of License Lamp (W/ Step Bumper)

Courtesy of GENERAL MOTORS CORP.

Install the bulb.
Install the rear edge of the lens housing into the rear bumper.
Push on the lens side of the housing in order to snap the housing into the rear bumper assembly.
Inspect the operation.