Circuit/System Verification
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, command the following ON and OFF with a scan tool. The respective turn signal lamp should turn on and off.
- LF Turn Signal
- LR Turn Signal
- RF Turn Signal
- RR Turn Signal
- If the turn signal lamp is always on or does not turn on, refer to Turn Signal Lamp Circuit Malfunction below.
- Ignition ON, operate the left and right turn signals from the multifunction/turn signal switch and verify the left and right turn signal lamps and indicators operate normal.
- If the left or right turn signals do not operate, refer to the Turn Signal Switch Circuit Test below.