Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Ignition ON, observe the scan tool BCM Dimming Control Signal parameter while operating the dimmer switch from high to low. The reading should change from a high percent to a low percent as the switch is rotated.

If the reading does not change, refer to Dimmer Switch Circuit Test below.

If the scan tool dimmer control operates normal, refer to the Interior Backlighting Circuit Test or the LED Dimming Circuit Test below.