LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 980 (Sunroof System) >> Repair Instructions >> Sunroof Water Gutter Replacement (Extended Cab) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Tape off the perimeter of the sunroof window opening before removing the sunroof module to prevent scratching.
  1. Remove the air deflector. Refer to Sunroof Air Deflector Replacement (Extended Cab)  or Sunroof Air Deflector Replacement (Crew Cab) .
  2. Set the sunroof window to be in the open position of a minimum of 25 mm (1 in).
    3. IMPORTANT: It is only necessary to lower the headlinder. Only do those steps in headlinder replacement that will lower the headlinder enough to grain access.
  3. Remove the sunroof module assembly. Refer Sunroof Module Assembly Replacement .
    4. Fig 1: Screws And Water Gutter
    GM1825236Courtesy of GENERAL MOTORS CORP.
  4. Remove the screws (1) from the water gutter (2).
    5. Fig 2: Water Gutter & Retainers
    GM1825238Courtesy of GENERAL MOTORS CORP.
  5. Slide the water gutter rearward to release the retaining tabs (1) from the slots (2) in the track.
  6. Remove the water gutter (3) from the track.
scientia non olet · About LEMON Manuals