LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 980 (Sunroof System) >> Repair Instructions >> Sunroof Water Gutter Replacement (Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Water Gutter & Retainers
    GM1825238Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof water gutter to the sunroof window track.
  2. Seat the retaining tabs (1) on the water gutter (3) into the slots (2) in the track, and push the water gutter forward until the retaining tabs lock into place.
  3. Ensure that all 6 tabs are secured.
    4. Fig 2: Screws And Water Gutter
    GM1825236Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the water gutter screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the sunroof module. Refer Sunroof Module Assembly Replacement .
  6. Open the sunroof window to the fully open position.
  7. Install the air deflector. Refer to Sunroof Air Deflector Replacement (Extended Cab)  or Sunroof Air Deflector Replacement (Crew Cab) .
  8. Remove the tape from around the perimeter of the sunroof window.
  9. Verify that the sunroof is operating properly.
scientia non olet · About LEMON Manuals