Rear Seat Belt Retractor Replacement (Crew Cab)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Belt Retractor (Crew Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Disable the SIR. Refer to SIR Disabling and Enabling . Remove rear bench seat. Refer to Rear Seat Replacement (Crew Cab with A68) or Rear Seat Replacement (Extended Cab with A68) or Rear Seat Replacement (Extended Cab with AM7) . Remove the rear window lower molding. Refer to Rear Window Lower Garnish Molding Replacement (Regular Cab) or Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/A48) or Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/o A48) . Remove rear door sill plate. Refer to Rear Side Door Sill Plate Replacement (Extended Cab) or Rear Side Door Sill Plate Replacement (Crew Cab) . Remove the body lock pillar trim panel. Refer to Body Lock Pillar Trim Replacement (Crew Cab) or Body Lock Pillar Trim Replacement (Regular Cab) or Body Lock Pillar Trim Replacement (Extended Cab) .
1	Rear Seat Belt Anchor Plate Nut NOTE: Refer to Fastener Notice . Tighten: 45 N.m (33 lb ft)
2	Tighten: 45 N.m (33 lb ft)
3	Rear Seat Belt Guide
4	Rear Seat Belt Retractor Bolt Tighten: 45 N.m (33 lb ft)
5	Rear Seat Belt Assembly Tip: Route seat belt through slot in body lock pillar trim panel.