Conditions for Setting the DTC: Notes
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
All of the following conditions must exist for 5 seconds:
B0090 0F
- The SDM received a fault present message from the ROS.
- The ROS is in assembly plant mode and the SDM is in production mode.
- The SDM has not received any data from the ROS.
B0090 3A
- The SDM has received an ID message from the vehicle rollover sensor which does not match the ID stored in the SDM memory.
- The SDM has reset the vehicle rollover sensor twice without detecting the correct ID message.
B0090 39
- The SDM has received a Not Ok (NOK) message from the vehicle rollover sensor.
- The SDM has not received a message.