Circuit/System Verification
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- The seat belt pretensioners may deploy for impacts that are not severe enough to warrant frontal or side air bag deployment. The SDM is capable of sustaining 3 pretensioner deployment events, or one frontal or side deployment event. After the maximum number of deployments has occurred, DTC B0052 sets and becomes a latched code, which cannot be cleared.
- When DTC B0053 is accompanied by additional DTCs, other than B0052, repair the malfunction causing the other DTCs before replacing SDM.
- Ignition OFF, verify no signs of inflator module or pretensioner deployment exist.
- If any signs of deployment exist, refer to Repairs and Inspections Required After a Collision .
- Ignition ON, verify DTC B0052 or DTC B0053 is not set.
- If the DTC is set, clear DTCs. If DTC resets, replace the SDM.