Front Seat Cushion Frame Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Cushion Frame

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the front seat. Refer to Front Seat Replacement - Bucket .
1	Front Seat Adjuster Outer Finish Cover Refer to Front Seat Cushion Outer Trim Panel Replacement (Manual) or Front Seat Cushion Outer Trim Panel Replacement (Power) .
2	Front Seat Adjuster Inner Finish Cover Refer to Front Seat Cushion Inner Trim Panel Replacement .
3	Front Seat Riser Finish Cover Tip: Pull rearward to disengage the cover from the seat riser.
4	Seat Back Frame Bolt (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
5	Seat Cushion Cover and Pad Refer to Seat Cushion Trim Cover and Pad Replacement .
6	Front Seat Cushion Frame Nut (Qty: 4) Refer to Front Seat Adjuster Replacement (Power) . Tighten: 9 N.m (80 lb in)
7	Heated Seat Module Tip: Disconnect the electrical connector.
8	Front Seat Cushion Frame Tip: If working on the passenger seat, remove the inflatable restraint passenger presence system. Refer to Inflatable Restraint Passenger Presence System Replacement - Front .