LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Engine Cooling System) >> Repair Instructions >> Turbocharger Coolant Hoses/Pipes Replacement (LMM - Inlet Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Coolant Inlet & Outlet Hose Components
    GM1367360Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the inlet hose washer and inlet line.
  2. Install the turbocharger coolant inlet hose banjo bolt (1).

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Turbocharger Coolant Inlet Hose & Bypass Valve (6.6L, LMM)
    GM1868922Courtesy of GENERAL MOTORS CORP.
  3. Position the turbocharger coolant inlet hose clamp at the bypass valve.
  4. Remove the tape from the turbocharger openings.
    5. IMPORTANT: Lubricate the end of the duct prior to installation.
  5. Install the charged air cooler outlet pipe to the turbocharger and the charged air cooler. Refer to Charge Air Cooler Outlet Pipe Replacement .
  6. Install the air cleaner. Refer to Air Cleaner Assembly Replacement .
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  8. Fill the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill)  or Cooling System Draining and Filling (Static Fill) .
scientia non olet · About LEMON Manuals