Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing the rear coolant air bleed covers, remove the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) or Intake Manifold Replacement (L92 - Second Design) or Intake Manifold Replacement (LH6, LMG, LY5 and L76) . Otherwise proceed to the next step.
- Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- Drain the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill) or Cooling System Draining and Filling (Static Fill) .
- Reposition the radiator vent inlet hose clamp (1) at the coolant air bleed pipe fitting.
- Remove the radiator vent inlet hose (2) from the coolant air bleed pipe fitting.
- Remove the coolant air bleed pipe bolts (309) (intake manifold shown removed for clarity).
- Remove the coolant air bleed pipe (307) and seals (308).
- Remove the coolant air bleed cover bolts (312), if required.
- Remove the coolant air bleed covers (313) and seals (308), if required.
- Remove the seals (308) from the coolant air bleed pipe and/or covers.
- Discard the seals.