Endgate Emblem/Nameplate Replacement (GMC)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Endgate Emblem and Nameplate (GMC)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Endgate Nameplate/Emblem (Sierra) NOTE: Refer to Exterior Trim Emblem Removal Notice . Procedure Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the endgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Close the endgate prior to installing the new nameplate/emblem to the endgate. Remove the protective liner from the back side of the adhesive tape. Align the nameplate/emblem to the endgate and press to ensure full adhesion is made.
2	Endgate Nameplate/Emblem (GMC) NOTE: Refer to Exterior Trim Emblem Removal Notice . Procedure Use a J 25070 or equivalent to remove the old nameplate/emblem. Clean all the adhesive residue from the endgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate. When removing protective liners from adhesive backed nameplates/emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Close the endgate prior to installing the new nameplate/emblem to the endgate. Remove the protective liner from the back side of the adhesive tape. Align the nameplate/emblem to the endgate and press to ensure full adhesion is made.

Callout

Component Name

Endgate Nameplate/Emblem (Sierra)

NOTE: Refer to Exterior Trim Emblem Removal Notice .

Procedure

Use a J 25070 or equivalent to remove the old nameplate. Clean all the adhesive residue from the endgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the endgate prior to installing the new nameplate/emblem to the endgate.
Remove the protective liner from the back side of the adhesive tape.
Align the nameplate/emblem to the endgate and press to ensure full adhesion is made.

Endgate Nameplate/Emblem (GMC)

NOTE: Refer to Exterior Trim Emblem Removal Notice .

Procedure

Use a J 25070 or equivalent to remove the old nameplate/emblem. Clean all the adhesive residue from the endgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
When removing protective liners from adhesive backed nameplates/emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the endgate prior to installing the new nameplate/emblem to the endgate.
Remove the protective liner from the back side of the adhesive tape.
Align the nameplate/emblem to the endgate and press to ensure full adhesion is made.