LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube & Bolt
    GM1873233Courtesy of GENERAL MOTORS CORP.
  1. Install NEW O-ring seals onto the oil level indicator tube.
  2. Lightly lubricate the O-ring seals with engine oil.
  3. Install the oil level indicator tube.
    NOTE: Refer to Fastener Notice .
  4. Install the oil level indicator tube bolt at the indicator tube bracket.

    Tighten:  Tighten the bolt to 21 N.m (15 lb ft).

  5. Install the starter motor. Refer to Starter Motor Replacement (4.3L) or Starter Motor Replacement (4.8L, 5.3L, 6.0L, and 6.2L) or Starter Motor Replacement (6.6L) .
  6. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (4.3L) or Exhaust Manifold Replacement - Right Side (4.8L, 5.3L, 6.0L, and 6.2L) or Exhaust Manifold Replacement - Right Side (6.6L) .
  7. Install the oil level indicator.
scientia non olet · About LEMON Manuals