LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Intake Manifold Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Manifold Tube
    GM1873384Courtesy of GENERAL MOTORS CORP.
  1. If necessary, install NEW O-ring seals onto the tube.
  2. If necessary, install the intake manifold tube.
    3. Fig 2: View Of Air Inlet Tube & Components
    GM1873444Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the air inlet tube and NEW gaskets.
  4. Install the air inlet tube nuts and bolt.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  5. Connect the intake air heater electrical connector.
  6. Connect the MAP sensor electrical connector.
  7. Install the engine harness clip to the air inlet tube.
    8. Fig 3: View Of Air Inlet Tube To Intake Manifold Tube Bolt & Nut
    GM1873422Courtesy of GENERAL MOTORS CORP.
  8. Install the air inlet tube to intake manifold tube bolt and nut.

    Tighten:  Tighten the bolt/nut to 10 N.m (89 lb in).

    9. Fig 4: View Of Electrical Harness Bolts
    GM1873415Courtesy of GENERAL MOTORS CORP.
  9. Install the electrical harness bolts (1).

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

  10. Install the intake air valve. Refer to Intake Air Valve Replacement .
scientia non olet · About LEMON Manuals