LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 6.6L (2 Of 5)) >> On-Vehicle Repair Instructions >> Crankcase Ventilation Hoses/Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right PCV Hose/Pipe Bolt
    GM1335456Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the PCV hose/pipe.
  2. Install the right PCV hose/pipe bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    3. Fig 2: View Of Left PCV Hose/Pipe Bolt
    GM1335460Courtesy of GENERAL MOTORS CORP.
  3. Install the left PCV hose/pipe bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    4. Fig 3: View Of PCV Hose Clamp
    GM1335454Courtesy of GENERAL MOTORS CORP.
  4. Install the PCV hose to the air inlet pipe.
  5. Position the PCV hose clamp.
  6. Install the PCV hose to the clip on the top of the turbocharger.
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    8. Fig 4: View Of Turbocharger Clamp & Charged Air Cooler Inlet Duct Connector
    GM1334380Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Lubricate the end of the duct prior to installation.
  8. Remove the tape from the turbocharger openings.
  9. Install the charged air cooler inlet duct connector (4) to the turbocharger.
  10. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).

    Tighten:  Tighten the clamp to 6 N.m (53 lb in).

  11. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals