Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Pressure Sensor, Washer & Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS CORP.

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Sealers, Adhesives, and Lubricants .

NOTE: Refer to Fastener Notice .

If equipped with active fuel management perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707).
Tighten: Tighten the sensor to 35 N.m (26 lb ft).

Fig 2: View Of Oil Pressure Sensor & Washer

Courtesy of GENERAL MOTORS CORP.

If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707).

Fig 3: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS CORP.

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten: Tighten the sensor to 35 N.m (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) or Intake Manifold Replacement (L92 - Second Design) or Intake Manifold Replacement (LY2 and LY6) or Intake Manifold Replacement (LH6, LMG, LY5 and L76) .