LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 957 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Cylinder Head Removal - Left Side

Cylinder Head Removal - Left Side

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cylinder Head & Bolts
    GM1658150Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The cylinder head bolts are of a torque-to-yield design and are NOT to be used again. Install NEW cylinder head bolts during assembly.
  1. Remove the cylinder head bolts (220, 221).
    2. NOTE: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.
  2. Remove the cylinder head (218).
    3. Fig 2: View Of Cylinder Head Gasket & Locating Pins
    GM1658153Courtesy of GENERAL MOTORS CORP.
  3. Remove the gasket (217) and locating pins (230).
  4. Discard the gasket and cylinder head bolts.
scientia non olet · About LEMON Manuals