Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shock Absorber Mounting

Courtesy of GENERAL MOTORS CORP.

Install the shock absorber.
Install the upper shock absorber nut and bolt.

NOTE: Refer to Fastener Notice .

Install the lower shock absorber nut and bolt.
Tighten: Tighten the upper and lower shock absorber nuts to 95 N.m (70 lb ft).
Remove the support from the rear axle.
Remove the safety stands.
Lower the vehicle.