LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Steering Linkage) >> Repair Instructions >> Idler Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Idler Arm, Frame Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  1. Position the idler arm (2) to the vehicle frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the idler arm bolts (3) and nuts (1) to the frame.

    Tighten:  Tighten the bolts and nuts to 105 N.m (78 lb ft).

    3. Fig 2: View Of Idler Arm & Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
  3. Install the idler arm (1) to the relay rod (2).
    4. IMPORTANT: Do not reuse the old idler arm nut.
  4. Install the new idler arm nut (3) to the idler arm (1).

    Tighten:  Tighten the nut to 62 N.m (46 lb ft).

  5. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  6. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals