LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 952 (Transfer Case - Mp 1222/1225/1226-NQG) >> Repair Instructions - On Vehicle >> Transfer Case Control Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Before beginning the following service procedure, place the transmission into the PARK position. Then place the transfer case in the 2 HI position.
    Fig 1: Removing Transfer Case Control Rod From Control Lever
    GM649764Courtesy of GENERAL MOTORS CORP.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
    3. IMPORTANT: When performing this service procedure, use a small pocket screwdriver in order to release the retaining clip on the ends of the control rod.
  3. Remove the control rod from the control lever.
    4. Fig 2: View Of Transfer Case Control Rod
    GM396830Courtesy of GENERAL MOTORS CORP.
  4. Remove the control rod from the shift lever.
  5. Remove the control rod.
scientia non olet · About LEMON Manuals