Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Before installing a NEW control rod, loosen the adjusting bolt on the control rod so it slides with slight resistance.
When installing the control rod on the control levers, a snapping sound should be heard or felt upon installation.

Fig 1: View Of Transfer Case Control Rod

Courtesy of GENERAL MOTORS CORP.

Install the control rod onto the control lever first.

Fig 2: Installing Transfer Case Control Rod Onto Shift Control Lever

Courtesy of GENERAL MOTORS CORP.

Slide the control rod forward.
Install the control rod onto the shift control lever.

Fig 3: Tightening Transfer Case Control Rod Adjusting Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the control rod adjusting bolt.
Tighten: Tighten the bolt to 15 N.m (11 lb ft).
Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .