Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Air Cleaner Outlet Duct Clamp

Courtesy of GENERAL MOTORS CORP.

Loosen the air cleaner outlet duct clamp at the mass airflow (MAF)/intake air temperature (IAT) sensor.

Fig 2: Identifying PCV Hose

Courtesy of GENERAL MOTORS CORP.

Remove the positive crankcase ventilation (PCV) hose.

Fig 3: View Of Air Cleaner Adapter Nut

Courtesy of GENERAL MOTORS CORP.

Remove the air cleaner adapter nut.

Fig 4: View Of Air Cleaner Outlet Duct

Courtesy of GENERAL MOTORS CORP.

In order to remove the air cleaner outlet duct, pivot the duct upward until the hinge clip releases from the lip on the throttle body.

Fig 5: Heater Outlet Hoses

Courtesy of GENERAL MOTORS CORP.

Remove the heater outlet hose from the clip.
Move and secure the heater hoses out of the way.

Fig 6: Ignition Coil, Ignition Coil Driver, Ground Nut/Cable & Generator Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the following electrical connectors:
- The ignition coil (1)
- The ignition coil drive (2)
- The generator (3)
Disconnect the engine wiring harness clips.
Reposition the engine wiring harness.

Fig 7: Rocker Arm Cover

Courtesy of GENERAL MOTORS CORP.

Remove the rocker arm cover bolts.
Remove and discard the rocker arm cover bolt grommets, if necessary.
Remove the rocker arm cover.

Fig 8: View Of Rocker Arm Cover And Gasket

Courtesy of GENERAL MOTORS CORP.

Remove and discard the rocker arm cover gasket.
Clean and inspect the rocker arm cover, if necessary. Refer to Valve Rocker Arm Cover Cleaning and Inspection .