LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Tensioner Locating Pin
    GM869705Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the belt tensioner. Position the locating pin (1) on the tensioner into the hole in the generator bracket.
  2. Install the belt tensioner bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals