Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Generator Bracket Stud

Courtesy of GENERAL MOTORS CORP.

Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac-N-Fill) .
Remove the generator bracket. Refer to Generator Bracket Replacement (4.3L) .
Remove the intake manifold. Refer to Lower Intake Manifold Replacement .
Remove the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (4.3L) .
Remove the right pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
Remove the generator bracket stud from the cylinder head.

Fig 2: Locating Spark Plugs

Courtesy of GENERAL MOTORS CORP.

Remove the spark plugs.

Fig 3: Spark Plug Wire Support

Courtesy of GENERAL MOTORS CORP.

Remove the spark plug wire support bolts and support.

Fig 4: Locating Cylinder Head Bolts (Right)

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head bolts.

Fig 5: Removing/Installing Cylinder Head (Right)

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head.

Fig 6: View Of Cylinder Head Gasket And Alignment Pins - Right

Courtesy of GENERAL MOTORS CORP.

Remove and discard the cylinder head gasket.

Fig 7: Cylinder Head Locator Pins

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head locator pins, if necessary.
Clean and inspect the cylinder head, if necessary. Refer to Cylinder Head Cleaning and Inspection .
Disassemble the cylinder head, if necessary. Refer to Cylinder Head Disassemble .