LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Propeller Shaft Center Support Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement .
    3. Fig 1: Pressing The Propeller Shaft Down And Off The Center Bearing
    GM348612Courtesy of GENERAL MOTORS CORP.
  3. Remove the center bearing by doing the following:
    1. Stand the propeller shaft (2) on end in the press (1) with the center bearing (3) supported by the press bars (4).
    2. Press the propeller shaft (2) down and off the center bearing (3).
scientia non olet · About LEMON Manuals