LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 946 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (9.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the vehicle.
    • Route the vent hose the same way as when removed.
    • Ensure the hose is free of kinks and routes clear of sharp components.
    • Ensure the vent hose is not plugged.
  2. Connect the vent hose to the differential carrier assembly.
    3. Fig 2: Vent Hose & Wiring Bundle
    GM341716Courtesy of GENERAL MOTORS CORP.
  3. Install the vent hose (1) to the wiring bundle (2), S4WD axles only.
  4. Install the vent hose to the retainer clips, all axles.
  5. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals