LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 942 (Engine Controls And Fuel - 6.6L (LMM) - DTC P154B To DTC P2693) >> DTC P20E2 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Perform the Repair Verification after completing the Circuit/System Testing.
  1. Ignition OFF, disconnect both harness connectors at EGT sensor 1 and sensor 2.
  2. Ignition OFF for 90 seconds, Measure for a resistance of less than 5 ohms on each low reference circuit between terminals B and ground.
    • If the resistance is greater than the specified range, repair the open/high resistance on the affected circuit. If the circuit tests normal, replace the ECM.
  3. Ignition OFF, disconnect the harness connector X1 at the ECM.
  4. Test for less than 5 ohms of resistance on each of the following signal circuits:
    • ECM X1 signal circuit terminal 69 to EGT sensor 1 terminal A
    • ECM X1 signal circuit terminal 93 to EGT sensor 2 terminal A
    • If the resistance is greater than the specified range, repair the open/high resistance on the affected circuit.
  5. If all circuits test normal, remove and test each sensor.
scientia non olet · About LEMON Manuals