LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 942 (Engine Controls And Fuel - 6.6L (LMM) - DTC P154B To DTC P2693) >> DTC P154D >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
  1. Disconnect the IAH.
  2. Turn ON the ignition and measure between the temperature signal circuit terminal 1 and ground for 2-3 volts.
    • If greater than the specified range, test the temperature signal circuit for a short to voltage. If the circuit tests normal replaced the GPCM.
    • If less than the specified range, test the temperature signal circuit for a short to ground or open/high resistance. If the circuit tests normal replaced the GPCM.
  3. If the temperature signal circuit tests normal replace the IAH.