LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 934 (Automatic Transmission - 6L50/6L80/6L90 - DTC P0218 To DTC P0990) >> DTC P0722 or P0723 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition ON.
  2. Observe the transmission ISS/OSS supply voltage circuit status on the scan tool. The parameter should display OK.
    • If the parameter does not display OK, disconnect the ISS/OSS connector from the control solenoid (w/body and TCM) valve assembly and recheck the scan tool display.
    • If the transmission ISS/OSS supply voltage circuit status still displays OK, visually inspect the OSS, harness, connector, the control solenoid (w/body and TCM) valve assembly pins for metallic debris and output shaft machined surface for damage or misalignment.
    • Repair or replace the damaged components.
  3. Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test .
    • The scan tool Transmission OSS parameter should display 100-400 RPM.
    • If the Transmission OSS parameter is between 100-400 RPM, replace the ISS/OSS assembly.
    • If no OSS RPM is displayed or the parameter is out of range, replace the control solenoid (w/body and TCM) valve assembly.
scientia non olet · About LEMON Manuals