LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 934 (Automatic Transmission - 6L50/6L80/6L90 - DTC P0218 To DTC P0990) >> DTC P0716 or P0717 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the ignition ON, observe the transmission ISS/OSS supply voltage circuit status on the scan tool, the parameter should display OK.
    • If the circuit status does not display OK, disconnect the ISS/OSS connector from the control solenoid (w/body and TCM) valve assembly and recheck the scan tool display.
    • If the transmission ISS/OSS supply voltage circuit status still displays OK, visually inspect the ISS, harness, connector, the control solenoid (w/body and TCM) valve assembly pins for metallic debris and 1-2-3-4 and 3-5-R clutch housing machined teeth surface for damage or misalignment. Repair or replace any damaged components.
  2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test . The scan tool should display Transmission ISS between 100-400 RPM.
    • If 100-400 RPM ISS RPM is displayed, replace the ISS/OSS assembly.
    • If no ISS RPM is displayed or the RPM is out of range, replace the control solenoid (w/body and TCM) valve assembly.
scientia non olet · About LEMON Manuals